Marathon MAGNUM ROUTER - Manual (Page 60)

Chapter 7: Magnum Router GUI Manager
___________________________________________________________________
7-15
Figure 20 - Advanced Routing Screen
Adding an Advanced Routing Entry
To add an entry in the WAN IP Route Map screen, perform the following steps:
1. Click New Entry or press ALT-N
2. Enter data in the IP Address, Subnet Mask, and Gateway Address fields
3. Click Save Edit or press ALT-V to save the entry
4. Click Exit Edit or press ALT-X to return to the WAN IP Route Map screen.
Changing an Advanced Routing Entry
It is possible to change an entry after it has been entered into the table. Follow these steps to
change an entry:
1. Double-Click on the entry that needs modification in the table
This will cause all of the entry data to be loaded in the fields above the table.
2. Make any modifications required
3. Click on Save Edit or press ALT-V
4. Click on Exit Edit or press ALT-X
If this entry was selected by mistake and is not the one that needed modification, just click on
the Exit Edit or press ALT-X.
Deleting an Advanced Routing Entry
In some cases, an entry may need to be deleted. To do this, follow these steps:
1. Select an entry in the table.
2. Either click the Delete Entry button or press ALT-D.
3. A verification question is asked to make sure that this is the entry to delete, if it
is, select Yes. Selecting No will return to the Advanced Routing screen.
Repeat for each entry that is to be deleted.
Once the additional routes have been added, click on Save or press ALT-V to save any
changes, then click on Exit, or press ALT-X to return to the WAN-IP Route Map screen.
RIP Version 1 Routing
Enable RIP routing by clicking on the box next to Enable RIP Version 1 Routing. To disable
RIP routing, remove the check in the box.
The Magnum Router implements the RIP routing protocol in a “hybrid” fashion. It is covered in
more detail in chapter 8.