Marathon MAGNUM ROUTER - Manual (Page 64)

Chapter 7: Magnum Router GUI Manager
___________________________________________________________________
7-19
MVoIP Requirements
The requirements to add an MVoIP entry include an entry in the WAN configuration using a
DLCI of 900 thru 989 and an output port of E1; a WAN IP Route Map entry that uses a DLCI
from 900 thru 989, and an Ethernet Configuration entry. If any of these requirements are not
met, the Magnum Router Manager will report an error if the MVoIP button is clicked. One such
error is displayed below:
Adding an MVoIP Entry
To add an entry in the MVoIP screen, perform the following steps:
1. Click New Entry or press ALT-N
2. Select the MVoIP DLCI from the dropdown box, select the MVoIP type from the
dropdown box, enter data in the Source IP Address and destination IP address
3. Click Save Edit or press ALT-V
4. Click Exit Edit or press ALT-X
Changing an MVoIP Entry
It is possible to change an entry after it has been entered into the table. Follow these steps to
change an entry:
1. Double-Click on the entry that needs modification in the table
This will cause all of the entry data to be loaded in the fields above the table.
2. Make any modifications required
3. Click on Save Edit or press ALT-V
4. Clock on Exit Edit or press ALT-X
If this entry was selected by mistake and is not the one that needed modification, just click on
the Exit Edit or press ALT-X.
Deleting an MVoIP Entry
In some cases, an entry may need to be deleted. To do this, follow these steps:
1. Select an entry in the table.
2. Either click the Delete Entry button or press ALT-D.
3. A verification question is asked to make sure that this is the entry to delete, if it
is, select Yes. Selecting No will return to the MVoIP screen.
Repeat for each entry that is to be deleted.