Intermec PX4I - Manual (Page 30)

16 EasyCoder PX4i User’s Guide (IPL version)
Chapter 3 — Starting Up
Switching On the Printer
Before switching on the printer, make the necessary connections, and
check that the printhead is engaged.
Switch on the power using the On/Off switch on the rear plate. The
“Power” control lamp on the front panel lights up when the power is on.
Wait for a few moments, while the printer loads the program and runs
some self-diagnostic tests:
Starting
„„„„„„
After a short time, the printer is initialized. The progress of the initializa-
tion is indicated by an increasing number of colons on the lower line in
the display:
Initializing
:::
When the initialization is completed, a label is fed out. The following
message appears, indicating that the printer is ready for operation.
IPL 2.30
The message indicates the IPL version number.