Intermec PX4I User Manual
Page 90
76
EasyCoder PX4i User’s Guide (IPL version)
Chapter 9 — Troubleshooting
Note 1: This is only applicable for printers equipped with an EasyLAN interface.
Note 2: A printer that is equipped with an EasyLAN interface, but is not connected to
a network, will have a blinking IRI. To avoid this, the user can set “IP SELECTION” to
“MANUAL” and “IP ADDRESS” to “0.0.0.0”. This will indicate that the user does not
regard the lack of network connection as an error.
Note 3: No trap can be sent when this error/event occurs.
Note 4: This error indicates that the printer has not received an IP address. It is only
applicable for printers with IP SELECTION set to DHCP and/or BOOTP.
Note 5: At most, but not all, printer crashes, the console is reset. This will make the IRI
go off.
Note 6: If the printhead temperature raises above 100°C (212°F), an error occurs and
the printing will be paused until the printhead has cooled off. Meanwhile, the printer is
able to receive commands and data until the buffer is fi lled. The printing is automatically
resumed when the printhead temperature has reached 85°C (185°F).