Intermec PX4I - Manual (Page 58)


&BT Z$PE FS

19J

5c
5a
6
5b
44 EasyCoder PX4i User’s Guide (IPL version)
Chapter 5 — Thermal Transfer Printing
Ribbon Load, cont.
In case of ribbon 55 to 60 mm (2.16 to
2.3 inches) wide, compress the ribbon
supply bobbin and move it so it snaps
into the fi rst (innermost) groove. In case of 88 to 90 mm (3.5 inches)
ribbon width, compress the ribbon
supply bobbin and move it so it snaps
into the second groove.
Press the ribbon roll onto the ribbon
supply bobbin (1) and route the ribbon
through the print unit. Pull out 20 cm (8
inches) of ribbon. In case of 110 mm (4.3 inches) ribbon
width, compress the ribbon supply
bobbin and move it so it snaps into the
third groove.