IBM EGX-400 - Manual (Page 122)

118 Chapter 7 - Maintenance
Around the spindle head
Around the switch
Inside the X-axis rail
Use a commercially available brush to remove metal cuttings. Attempting to use a vacuum cleaner to take
up metal cuttings may cause fire in the vacuum cleaner.
Do not use a pneumatic blower to clean. Cutting dust may be hazardous to health. Breakdown of the ma-
chine may also occur.
Switch off the machine and unplug the power cord from the electrical outlet before performing cleaning
or maintenance. Failure to do so may result in injury or electrical shock.
Around the switch
Table and bed
Do not use solvents such as thinner, benzine, or alcohol
to clean.
7-1. Daily Care
Carefully clean away cutting waste. In addition to the table and bed, also clean the spindle head and the X-axis rail.
Around the memory-card slot