IBM EGX-400 - Manual (Page 86)

82 Chapter 5 - The Teaching Feature
5-5. Detailed Information on Saving a Sequence
Destinations for Saving Sequences
You can save sequences either in the machine's built-in memory or on a memory card. You can save up to ten sequences
in the built-in memory. The number you can save on a memory card varies according to the card's capacity. Note that the
maximum is 512.
Specify either the built-in memory or a memory card for saving or calling up a file. A file displayed with [Int.] is in the
machine's built-in memory, and one displayed with [Ext.] is on a memory card.
When saving a file, if you want to save it as a new file with a different name, select [new file], then enter the file name.
If you want to save it by overwriting the existing file, select the name of the existing file. When you do this, a prompt is
displayed to confirm that you want to overwrite the file.
Select File
Int. new file
Int. new file .................................. Saving as a new file
Int. File name 1
......................
Int.
File name 2
Ext. new file ................................. Saving as a new file
Ext. File name 1
......................
Ext.
File name 2
○
○○○
Built-in memory ...........
Memory card ...............
Dial
A prompt to confirm overwriting is displayed.
Saving by overwriting
the existing file
Saving by overwriting
the existing file
OverWrite File ?
Yes No
There may be a slight delay of several seconds to several dozen seconds until the file-
selection screen appears. During this time, do not try to remove the memory card or
switch off the power.
Now Processing...