IBM EGX-400 - Manual (Page 54)

50 Chapter 3 - Preparations
3-4. Cutter Installation Method 3 (Diamond Scraper)
Cutting Parameters for the Diamond Scraper
When you use the preceding method, there is no need to set the cutting-in depth or the cut-out amount. The cutting-in
depth is determined by the pressure of the cutter. (The preceding method produces a uniform cutter force for the ma-
chine.)
For more information about how to set the cutting parameters
☞ See p.59 "Setting the Cutting Parameters"
☞ See p.134 "Examples of Settings for Cutting Parameters"
For detailed information about the cutting-in depth and cut-out amount
☞ See p.110 in "Detailed Description of the Menus," the section "AUTO Z CONTROL"