IBM EGX-400 - Manual (Page 28)

24 Chapter 2 - Basic Operation
2-1. Emergency Stop to Ensure Safety
How to Perform an Emergency Stop
To stop the machine in an emergency in order to avoid danger, press the emergency stop switch. The machine immedi-
ately stops operating and quits cutting. Cutting cannot be resumed.
To Cancel an Emergency Stop
To cancel an emergency stop, turn the emergency stop switch in the direction of the arrow. The machine returns to the
state it was in immediately after powerup.
Opening and Closing the Spindle Cover
Be sure to close the spindle cover before you start cutting, and never open it while operation is in progress. For safety,
opening the spindle cover during operation causes an emergency stop. To recover, switch off the power to the machine.
When the spindle cover is open, only head movement using the movement buttons is possible. You cannot use the buttons
to rotate the spindle or perform cutting.