InFocus IN82 - Manual (Page 10)

9
Displaying an image
Connect the power cord to the Power connector on the back of the projector
and to your electrical outlet.
NOTE: Always use the power cord that shipped with the projector.
Press the Power button on the remote.
The Power light on the Status Indicator Panel blinks green and the fans start to
run. When the lamp comes on, the start up screen displays and the Power light is
solid green. It can take a minute for the image to achieve full brightness.
? No start up screen? Get help on page 12.
Plug in, connect, and turn on your video device.
The video source’s image should appear on the projection screen. If it doesn’t,
press the Source button on the remote until the image appears.
? No image? Try pressing the Auto Image button on the remote. Get help
on page 12.
Adjusting the image
Adjust the height of the image by tilting the projector up or down, either using the
base or the ceiling mount.
Position the projector the desired distance from the screen at a 90 degree angle to
the screen.
See page 5 for a table listing screen sizes and distances to the screen.
plug in Power cord
press Power button
turn on video device
adjust height
K1 RG.fm Page 9 Thursday, September 27, 2007 10:24 AM