InFocus IN82 - Manual (Page 12)

11
Shutting down the projector
Power Save
The projector also has a Power Save feature that automatically turns the lamp off
after no active sources are detected and no user interaction with the projector is
performed for 20 minutes. By default, this feature is on. See page 24.
Sleep Timer
The projector also has a sleep timer feature that automatically turns the projector
off after 4 hours. See page 24.
Turning off the projector
Press the Power button on the remote to turn the projector off. The lamp turns
off and the Power light on the Status Indicator Panel blinks amber for one (1)
minute while the fans continue to run to cool the lamp. While the light is blinking,
the projector does not accept any keypad and remote control input. When the
lamp has cooled, the Power light is solid amber.
Troubleshooting your setup
If your image appears correctly on the screen, skip to the next section. If it does
not, troubleshoot the setup.
The Status Indicator Panel on top of the projector indicates the state of the pro-
jector and can help you troubleshoot.
The following tables show common problems. In some cases, more than one possi-
ble solution is provided. Try the solutions in the order they are presented. When
the problem is solved, you can skip the additional solutions.
Table 2: Status indicator light behavior and meaning
Status Indicator Meaning
Power, green Powering up or powered up
Solid: the lamp is on and an image is dis-
played.
Blinking: the projector is powering up.
Power, amber Powering down or powered down
Solid: the lamp is off and the projector is
in standby.
Blinking: the projector is powering down
and the fans are running to cool the lamp.
Temperature The projector is too hot. Make sure the
vents aren’t blocked. Turn off the projec-
tor and wait one minute, then turn the
projector on again. Contact Technical
Support if the problem persists
.
Lamp Turn off the projector and wait one
minute, then turn the projector on again.
If the lamp light turns on again, replace the
lamp and reset the lamp timer.
Service Turn off the projector and wait one
minute, then turn the projector on again.
If the service lamp turns on again, service
is required. Visit www.infocus.com/service
to contact Service.
K1 RG.fm Page 11 Thursday, September 27, 2007 10:24 AM