InFocus IN82 - Manual (Page 5)

4
Connector Panel
Remove the cable cover, if attached, to access the connector panel. Replace the
cover after the projector is installed, if desired.
The projector provides the following connection options:
• M1-DA/DVI (Digital Visual Interface)
• HDMI™ (High Definition Multimedia Interface)
• Component (RCA)
• S-video
• Composite video (RCA)
See “Video connectors” on page 7 for details.
The projector also provides the following connectors:
• RS-232 for serial control
• Two 12 volt DC outputs (see below)
• IR input for connection to Niles/Xantech compatible IR repeater systems
12 volt DC outputs
The 3.5mm mini-jack triggers provide a 12 volt, 0.25 amp DC output. They provide
a constant output while the projector is on. They are typically used for screen con-
trol. For example, if you connect your projection screen to the vertical screen trig-
ger with the cable that came with your screen, when you turn on the projector the
screen will move down; when you turn the projector off, the screen will return to
the storage position. The horizontal screen trigger output can be used to control
curtains or an adjustable aspect ratio screen.
M1-DA/
S-video
component
composite
HDMI
RS-232
DVI
RCA
IR input
RCA 12 volt DC output
+12v
ground
3.5mm plug
to, for example, screen relay (see screen manufacturer
for details)
K1 RG.fm Page 4 Thursday, September 27, 2007 10:24 AM