InFocus IN82 - Manual (Page 25)

24
Settings menu
Sources: allows programming of source buttons, enables autosource, and enables
the SCART RGB source. When Autosource is selected, the Source Enable fea-
ture indicates which sources the projector attempts to lock onto. You can use the
Source Enable feature to eliminate certain sources from this search, which will
speed the search. By default, the check boxes for all sources are checked except
SCART RGB. Uncheck a source box to eliminate it from the search. When Auto-
source is not checked, the projector defaults to Component initially, then defaults
to whatever the last active source was when the projector was powered down. To
display another source, you must manually select one by pressing the Source but-
ton on the remote. This cycles through all the sources that are selected in the
Source Enable menu.
The Source 1, 2, and 3 menus in the Sources menu allow you to assign a source to
the Source 1, 2, and 3 buttons on the remote. The Source 4 menu selection would
apply to the Custom key if that option is chosen in the Custom key menu, see
page 25. To use the SCART RGB source, you must first select it in the Source
Enable menu (the projector cannot automatically detect this source). Enabling
SCART will disable Component and Composite sources.
System>OSD Offset: allows you to adjust the position of the OSD. By default,
the menus are postponed in the upper lefthand corner of the displayed image and
the messages are postponed in the lower lefthand corner. Adjust the offset to
move these items more to the right and middle of the display. Rear: reverses the
image so you can project from behind a translucent screen. Ceiling: turns the
image upside down for ceiling-mounted projection.
Auto Ceiling: uses an internal
sensor to automatically turn on ceiling mount mode if the projector is inverted.
High Power: maximizes the light output of the lamp. Auto Power: When Auto
Power is checked, the projector automatically goes into the startup state after the
projector receives power. This allows control of ceiling mounted projectors with a
wall power switch.
Settings menu
Sources
Source
Enable
System menu
K1 RG.fm Page 24 Thursday, September 27, 2007 10:24 AM