Integra DTR-6.4/5.4 - Manual (Page 25)

25
Connecting antennas
Make sure to follow the general rules given below:
• Keep the antenna away from noise sources (neon signs, busy
roads, etc.).
• It is dangerous to put the antenna close to power lines. Keep it
well away from power lines, transformers, etc.
If reception is poor with the indoor AM antenna, stretch out the
outdoor antenna (16 feet (5 meters) or more) above a window or
outside.
• Keep the indoor AM loop antenna connected. Do not remove it.
Connecting an FM outdoor antenna
Connecting an AM outdoor antenna
VIDEO 2 DVD MO
OU
VIDEO 1 VIDEO 3
IN IN IN IN OUT OUT
ANTENNA FM 75 AM
IR OUT
56K
A
40K
B
ZONE 2
OUT
DC IN
24V 1A
L
R
ZONE 2
LINE OUT
ZONE 2
12 V
RIGGER
OUT
AL
VIDEO 2 DVD M
O
VIDEO 1 VIDEO 3
IN IN IN IN OUT OUT
ANTENNA FM 75 AM
IR OUT
56K
A
40K
B
ZONE 2
OUT
DC IN
24V 1A
L
R
ZONE 2
LINE OUT
ZONE 2
12 V
IGGER
OUT
L
(Indoor)
AM loop antenna
Insulated antenna
cable
Do not use the same antenna for both FM and TV (or VCR)
reception since the FM and TV (or VCR) signals can interfere with
each other. If you must use a common FM/TV (or VCR) antenna,
use a directional linkage type splitter.
Connecting the 300 Ω ribbon wire:
Loosen the screws on the adapter and wrap the wires of the ribbon
wire around these screws. Then tighten the screws down with a
screwdriver.
Connecting the coaxial cable:
1. With your fingernail, or a small screwdriver, press the
stoppers of the 75/300 Ω antenna adapter outward
and remove the cover.
2. Remove the transformer wire A from slit B and insert
it into slit C.
3. Prepare the coaxial cable as shown in the diagram.
4. Connect the 75/300 Ω antenna adapter to the coaxial
cable.
1. Insert the end of the cable.
2. Clamp it in place with pliers.
5. Reinstall the cover.
Directional linkage
Connecting the antenna cable to the 75/300
Ω
antenna adapter (Australian models only)
To TV (or VCR) To receiver
Outdoor
antenna
300 Ω
ribbon wire
1 2 3, 4
✦ ✦ ✦
✦ ✦ ✦ ✦ ✦
✦ ✦ ✦
6
mm
3
mm
6
mm
5/8"
(15mm)
Wire A
Slit C
Slit B