Integra DTR-6.4/5.4 - Manual (Page 38)

38
Enjoying music or videos with the DTR-6.4/5.4
-- / ---
1 2 3
4 5 6
+10 0
7 8 9
Audio Sel Muting
Angle Subtitle TV / VCR
Random Audio Adjust
Enter
Search
Input Selector
Dimmer Zone 2 Display
SURR THX
Stereo Direct
All ST
C H
Disc
Pure A
Rec
DSP DSP Re-EQ
Level
A M
V 1
DVD
V 3 V 4 V 5
C D
V 2
P H
TAP TUN
RC-534M
VOL
Display
Level /
RCVR Mode
Display
CH Sel
While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the Display button on the DTR-6.4/5.4 or the remote
controller.
You can set separate video displays for when the input source is set
to AM or FM broadcasts and for when it is set to anything else.
When an input source other than FM or AM is selected:
* When the input signal is digital audio
The program format is displayed. For example, the display
“Dolby D: 3/2.1” shows that the format is Dolby Digital with 5.1
discrete channels consisting of three front channels (front left,
front right, and center), two surround channels (surround left and
surround right), and the low frequency effect (LFE) channel.
When the front channel number is 2, they are the front left and front
right; when it is 1, it is monaural. When the surround channel
number is 1, it is monaural; when it is 0, there is no surround channel.
When no LFE number is given, there is no LFE channel. Also, if
there is no program format for the input signal, nothing will be
displayed.
When the input signal is linear PCM
The sampling frequency is displayed. For example, the display
“PCM fs: 44.1k” shows that the signal is PCM and that the
sampling frequency is 44.1 kHz.
When FM or AM is selected as the input source:
Switching the display
-- / ---
+10
Display
Remote controller DTR-6.4/5.4
Input + volume
Program format or
sampling
frequency*
Input + Listening
mode or Multich
FM/AM frequency +
Preset no.
FM/AM + Listening
mode
To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 and +12
decibels. For subwoofer, values between –15 and +12 decibels can be
set. Note that the calibration settings will return to the original
settings when the DTR-6.4/5.4 is put in standby.
Using the remote controller:
1. Press the RCVR Mode button.
2. Press the CH Sel button and select
the desired speaker.
3. Press the Level or button to
adjust the volume level.
Notes:
• You cannot select a speaker if the configuration value of the
speaker is set to “No” or “None.”
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume level.
• When you press the Test button after you set the level, the
current level will be used as the value set via the test tone.
Temporarily changing the speaker output levels
Angle Subtitle
Level