Integra DTR-6.4/5.4 - Manual (Page 37)

37
Enjoying music or videos with the DTR-6.4/5.4
-- / ---
1 2 3
4 5 6
+10 0
7 8 9
Audio Sel Muting
Angle Subtitle TV / VCR
Random Audio Adjust
Enter
Search
Input Selector
Dimmer Zone 2 Display
SURR THX
Stereo Direct
All ST
C H
Disc
Pure A
Rec
DSP DSP Re-EQ
Level
A M
V 1
DVD
V 3 V 4 V 5
C D
V 2
P H
TAP TUN
RC-534M
VOL
Phones
Dimmer
Muting
Dimmer
Sleep
To turn off the sound momentarily, press the
Muting button on the remote controller. The
Muting indicator will flash and the sound from the
speakers or headphones will be switched off by
the receiver’s audio muting circuit. Press the
Muting button again to turn the sound back on.
To listen with headphones, plug a pair of headphones with a
standard stereo plug into the Phones jack on the DTR-6.4/5.4 front
panel.
When you connect the headphones, the DTR-6.4/5.4 will enter the
STEREO mode automatically and no sound will be heard from the
speakers. When the headphones are unplugged, the DTR-6.4/5.4
returns to its original listening mode. When using the headphones,
you can only use the Direct, Stereo, and Pure Audio (DTR-6.4 only)
listening modes. If you have selected multichannel audio, you will
only hear the sound output to the front right and left channels.
The headphone volume level can be adjusted at the Setup Menu (see
page 58).
Note:
The signal to the remote zone (Zone 2) will not be affected by
whether or not headphones are connected
Temporarily turning off the sound
Listening with headphones
Muting
M
Remote
controller
Flashes
The Sleep button enables you to set the DTR-6.4/5.4 to turn off
automatically after a specified time period. If you press it once, the
DTR-6.4/5.4 will turn off after 90 minutes. Each time it is pressed
thereafter, this remaining time until the DTR-6.4/5.4 turns off
decreases by 10 minutes (i.e., from 90 to 80 minutes). While the
sleep function is enabled, you can press the Sleep button to see how
much time is left. If the Sleep button is pressed when the time
displayed is less than 10 minutes, the sleep function is cancelled.
If you are using the remote zone (Zone 2), it will turn off at the
same time as the main zone. If you want to set the sleep function for
Zone 2 only, set the sleep function with the main zone turned on and
then put the main zone into the standby state.
You can adjust the brightness of the front display of the DTR-6.4/
5.4 using the Dimmer button on the remote controller or on the
DTR-6.4/5.4 front panel.
Using the sleep time (remote controller only)
Adjusting the brightness of the front display
Remote controller
0
Dimmer
DTR-6.4/5.4 Remote controller