Integra DTR-6.4/5.4 - Manual (Page 40)

40
Enjoying DVD multichannel audio playback
-- / ---
1 2 3
4 5 6
+10 0
7 8 9
Audio Sel Muting
Angle Subtitle TV / VCR
Random Audio Adjust
Enter
Search
Input Selector
Dimmer Zone 2 Display
SURR THX
Stereo Direct
All ST
C H
Disc
Pure A
Rec
DSP DSP Re-EQ
Level
A M
V 1
DVD
V 3 V 4 V 5
C D
V 2
P H
TAP TUN
RC-534M
VOL
Master Volume
Stereo (DTR-6.4)
Direct (DTR-5.4)
VOL
Audio Adjust
Direct
Audio Sel
SURR
Audio Adjust
Surround (DTR-5.4)
Direct/Pure Audio
(DTR-6.4)
Surround (DTR-6.4)
Stereo (DTR-5.4)
Audio Selector
When you made multichannel connection (5.1ch) between your
DVD player and the DTR-6.4/5.4, you can enjoy analog
multichannel audio playback. Make sure that your connection is
identical to the connection shown in “Connecting a DVD Player
with 5.1-Channel Output” (page 20).
1. Press the DVD input source button.
2. Select “Multich” using the Audio Selector button on
the front panel (or Audio Sel button on the remote
controller).
3. Turn on the connected DVD player and start playing
the desired media.
4. If necessary, adjust the output level of each speaker
as desired (see page 38).
Adjust the volume at each speaker so that all the volumes sound
at the same level at the listening position. For the front right,
front left, center, surround right, and surround left speakers, the
output levels can be adjusted between –12 and +12 decibels.
The subwoofer can be adjusted between –30 and +12 decibels.
5. Adjust the volume with the Master Volume dial or the
VOL buttons on the remote controller.
Note:
(DTR-6.4 only) When you turn on the tone control (see the next
section), the settings in “Speaker Config” and “Speaker Distance”
will be used for multichannel playback.
If you change the speaker levels in step 4 above, these new levels
for multichannel sources will have no effect on the settings at
“Level Calibration.”
Basic operation
Audio Sel
A
Remote controller DTR-6.4/5.4
To make bass and treble adjustment work for multichannel sources,
you must first set the tone control to “On.”
To turn on the tone control:
1. Press the Surround button (or SURR button on the
remote controller).
“Tone On” appears on the display and the tone control is turned
on.
2. Press the Audio Adjust button and then the and
cursor buttons to select Bass (or Treble).
3. Press the and cursor buttons to set the desired
level.
The Bass (or Treble) can be adjusted between –12 and +12
decibels in 2dB steps.
Using the tone control
4
SURR
Remote controller DTR-6.4/5.4
Audio Adjust
DTR-6.4/5.4 Remote controller
Remote controller DTR-6.4/5.4