Integra DTR-6.4/5.4 - Manual (Page 73)

73
Using the macro function
-- / ---
1 2 3
4 5 6
+10 0
7 8 9
Audio Sel Muting
Angle Subtitle
TV / VCR
Random Audio Adjust
Enter
Search
Input Selector
Dimmer Zone 2 Display
SURR THX
Stereo Direct
All ST
VOL C H
Disc
Pure A
Rec
DSP DSP Re-EQ
Level
A M
V 1
DVD
V 3 V 4 V 5
C D
V 2
P H
TAP TUN
RC-534M
Macro 1 Macro 2
Enter
Send/Learn
indicator
Mode buttons
-- / ---
1 2 3
4 5 6
+10 0
7 8 9
Audio Sel Muting
Angle Subtitle
TV / VCR
Random Audio Adjust
Enter
Search
Input Selector
Dimmer Zone 2 Display
SURR THX
Stereo Direct
All ST
VOL C H
Disc
Pure A
Rec
DSP DSP Re-EQ
Level
A M
V 1
DVD
V 3 V 4 V 5
C D
V 2
P H
TAP TUN
RC-534M
On Standby
Enter
Send/Learn
indicator
1. Press and hold down any one of the seven Mode
buttons, press the Macro 1 (or 2) button, and then
release both buttons.
When you press the Mode button, it lights and the Send/Learn
indicator lights. When you press the Macro 1 (or 2) button, the
indicator turns off. When you release the buttons, the indicator
flashes once.
2. Press the Macro 1 (or 2) button again.
The Send/Learn indicator slowly flashes twice. The macro
programmed to the Macro button is erased.
Notes:
• If the Send/Learn indicator quickly flashes three times and turns
off, then the remote controller has exited the erasing mode
because either you have made a mistake during erasing or a
time-out has occurred because no button has been pressed.
Resume from Step 1.
• If you press a button other than Macro 1 (or 2) button in Step 2,
then you will in effect be overwriting the previous macro with a
new macro.
This procedure will erase all the commands and macros that you
have programmed into the remote controller and return it to its
default settings. This operation will not affect the preset settings of
the remote controller.
1. Open the battery cover and remove the batteries from
the remote controller.
2. While pressing and holding down the On and Standby
buttons, re-insert the batteries in their correct
orientation, and then release both buttons.
The Send/Learn indicator flashes slowly.
3. Press the ENTER button.
The Send/Learn indicator lights up for about ten seconds and
then turns off.
All programmed commands and macros are erased and the remote
controller returns to its factory presets.
Notes:
• Proceed to Step 3 immediately after Step 2; otherwise, the
batteries will be consumed quickly.
• If you press any button other than the ENTER button in Step 3,
nothing will be erased. In this case, resume from Step 1.
Erasing a macro from the Macro 1 (or 2) button
Erasing all commands and macros that have
been programmed