Invacare 9000 Topaz - Manual (Page 32)

5 FRONT RIGGINGS
Invacare®9000 Topaz™Wheelchair 32 Part No 1100869
5.2 Swingaway Footrest Height Adjustment
1. Remove the swingaway footrest assembly. Refer to
Installing/Removing Swingaway Footrest Assembly on page 31.
2. Remove the two bolts and locknuts that secure the lower footrest
assembly to the upper footrest support.
3. Reposition the lower footrest assembly to the desired height.
4. Install and securely tighten the two bolts and locknuts.
5. Repeat STEPS 1-4 for the other footrest.
6. Reinstall the swingaway footrest assembly. Refer to
Installing/Removing Swingaway Footrest Assembly on page 31.
FIGURE 2 Swingaway Footrest Height Adjustment
5.3 Installing/Removing Elevating Legrest Assembly
Installing
1. Place elevating legrest assembly on the outside of the wheelchair and install the hinge plates onto the hinge pins on the wheelchair frame.
2. Rotate elevating legrest assembly toward the inside of the wheelchair until it locks in place.
3. Repeat STEPS 1 and 2 for the other legrest assembly.
 Lay the assembly on a flat surface to simplify this
procedure.
Lower
Footrest
Assembly
Bolts and Locknuts
Upper
Footrest
Support

For this procedure, refer to FIGURE 3 on page 33.

The footplates will be facing each other when locked in place.