Invacare 9000 Topaz - Manual (Page 54)

11 OPTIONS
Invacare®9000 Topaz™Wheelchair 54 Part No 1100869
11.3 Wheel Lock Extension Handle
1. Remove the existing rubber tip from the wheel lock handle. Discard rubber tip.
2. Secure the wheel lock extension handle to the wheelchair frame by wrapping the elastic cord around the wheelchair frame.
3. Pass the wheel lock extension handle through the loop end of the elastic cord.
4. Slide the wheel lock extension handle on to the wheel lock handle.
5. Repeat STEPS 1-4 for the remaining wheel lock.
FIGURE 3 Wheel Lock Extension Handle
ƽ
WARNING
If the wheelchair is equipped with push to lock wheel locks, elevating legrests, and wheel lock extension handles, the wheel
lock extension handles MUST be removed before swinging the elevating legrests to the side, otherwise injury or damage
may result. Interference between the top of the elevating legrest and the wheel lock extension handle causes the wheel lock
to disengage.
Elastic Cord (Loop End)
Wheelchair Frame
Wheel Lock Handle
Wheel Lock Extension Handle