Removing, Elevating legrest assembly, 4 adjusting elevating legrest assembly – Invacare 9000 Topaz User Manual
Page 33: Adjusting footrest height, Repeat steps 1-2 on remaining legrest assembly, Adjusting calfpad, 5 front riggings
5 FRONT RIGGINGS
33
Invacare®9000 Topaz™Wheelchair
4.
While sitting in the wheelchair, adjust the legrest to the correct height. Refer to Adjusting Elevating Legrest Assembly on page 33.
Removing
1.
Ensure the elevating legrest is in the lowered position. Refer to
Adjusting Elevating Legrest Assembly on page 33.
2.
To release the elevating legrest assembly push the legrest release
handle toward the inside of the wheelchair (facing the front of the
wheelchair) and swing the legrest assembly to the outside of the
wheelchair.
3.
Lift the elevating legrest assembly off the hinge pins.
FIGURE 3 Installing/Removing Elevating Legrest Assembly
5.4
Adjusting Elevating Legrest Assembly
Adjusting Footrest Height
1.
While sitting in the wheelchair, remove the two bolts and locknuts securing the lower footrest assembly to the elevating legrest assembly and
move the lower footrest assembly up or down until the desired height is achieved.
2.
Secure the lower footrest assembly to the elevating legrest assembly with the two bolts and locknuts. Securely tighten.
3.
Repeat STEPS 1-2 on remaining legrest assembly.
Adjusting Calfpad
1.
Remove the two mounting screws securing the calfpad to the calfpad support of the elevating legrest assembly.
2.
Slide the Calfpad up or down until the desired position is obtained.
Elevating Legrest Assembly
Legrest Release Lever
Hinge
Pins