JVC CA-MD70R - Manual (Page 21)

– 20 –
English
Playing Back the Entire Discs — Continuous
Play
You can play CDs continuously.
1
Load CDs.
2
Press one of the disc number buttons (CD 1, CD 2
and CD 3) for the disc you want to play.
CD playback starts from the first track of the selected
disc.
• Pressing CD
6 instead of the disc number buttons
starts playing back the CD whose disc number lamp
lights green.
To stop during play, press
7 of the CD control.
To remove the disc, press the corresponding open/close
buttons (
0 1 to 0 3).
CD playback sequence
When 3 CDs are loaded in the disc compartment, they are played
in one of the following sequences.
• When CD 1 is pressed : CD 1
] CD 2 ] CD 3 (then stops)
• When CD 2 is pressed : CD 2 ] CD 3 ] CD 1 (then stops)
• When CD 3 is pressed : CD 3 ] CD 1 ] CD 2 (then stops)
* When only 2 CDs are loaded, they are played in the same order,
but the disc tray without a CD is skipped.
Basic CD Operations
While playing a CD, you can do the following operations.
To exchange CDs during playback of another
Press the open/close button (
0 1 to 0 3) corresponding to a
disc number whose disc number lamp is lit orange to eject
that disc tray and exchange the CD.
When CDs are exchanged during playback, playback stops
after playing the last exchanged CD.
To stop playback for a moment
Press CD 6.
To resume play, press CD 6 again.
Continued
Disc No. Track No. Elapsed playing time
To locate a particular point in a track
During play, press and hold
4 or ¢ of the CD control.
• 4 : Fast reverses the disc.
•
¢ : Fast forwards the disc.
To go to another track
Press
4 or ¢ of the CD control repeatedly before or
during playback.
•
4 :Goes back to the beginning of the current or
previous tracks.
•
¢ :Skips to the beginning of the next or succeeding
tracks.
Rotating MULTI JOG on the unit also changes the tracks.
To go to another track directly using the number
buttons
Pressing the number button(s) allows you to start playing
the track number you want. (Make sure that you have
pressed one of the following buttons — disc number
buttons (CD 1, CD 2, CD 3) and CD
6 — on the remote
control before using the number buttons.)
Ex.: For track number 5, press 5.
For track number 15, press +10 then 5.
For track number 20, press +10, then 10.
For track number 32, press +10 , +10, +10, then 2.
Programming the Playing Order of the
Tracks — Program Play
You can arrange the order in which the tracks play before
you start playing. You can program up to 32 tracks.
1
Load discs.
• If the current playing source is not the CD player,
press CD
6, then 7 of the CD control before going
to the next step.
2
Press PLAY MODE so that “PROGRAM” appears
in the main display.
• Each time you press the button, play mode changes
as follows:
Disc No.
Track No.
Step No.
Continued
PROGRAM
Canceled
(Continuous play)
RANDOM
EN19-31.CA-MD70R[E]/F 98.11.6, 11:52 am 20