JVC CA-MD70R - Manual (Page 37)

– 36 –
English
8
Press SET.
• If you have selected wrong tracks, press CANCEL,
then select the correct tracks by rotating MULTI
JOG.
• If you want to cancel the editing, press CANCEL.
9
Press ENTER to finish the editing procedures.
10
Press
0 to eject the MD.
“WRITING” appears while the editing you have
made is being recorded on the MD.
ERASE Function
This function allows you to erase an unwanted track.
• To do the following procedures, use the buttons and
controls on the unit.
• To stop any time during editing process, press MD EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
The MD IN lamp lights.
2
Press MD EDIT.
The MD recorder enters editing mode (with DIVIDE
function selected).
3
Rotate MULTI JOG until “ERASE” is selected.
4
Press SET.
5
Rotate MULTI JOG to select the track you want to
erase.
6
Press SET.
• If you have selected a wrong track number, press
CANCEL, then select the correct track number.
7
Repeat steps 5 and 6 if you want to erase more
tracks (up to 16).
8
Press ENTER to finish your selection of tracks to
erase.
• If you want to cancel the editing, press CANCEL.
9
Press ENTER again.
10
Press
0 to eject the MD.
“WRITING” appears while the editing you have
made is being recorded on the MD.
Continued
EN32-52.CA-MD70R[E]/F 98.11.6, 11:56 am 36