JVC CA-MD70R - Manual (Page 34)

– 33 –
English
DIVIDE Function
This function allows you to divide one track into two
separate tracks. It is useful, for example, when you want to
add track marks at a certain point within a track or if you
want to separate a recording.
• To do the following procedures, use the buttons and
controls on the unit.
• To stop any time during editing process, press MD EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
The MD IN lamp lights.
2
Press MD EDIT.
The MD recorder enters editing mode (with DIVIDE
function selected).
3
Press SET.
The information of the first track (or the current track,
if during play) of the MD appears in the main display,
and playback starts.
4
Rotate MULTI JOG to select the track you want to
divide.
• If you have selected a wrong track, press CANCEL
then select the correct track.
5
Press SET when you find the point where you want
to divide the track.
The MD recorder repeats the selected point — a
portion of 3 seconds length following the dividing
point.
• If the dividing point is satisfactory, go to step 7.
• If the dividing point is not satisfactory, go to the next
step
6
Rotate MULTI JOG to precisely adjust the dividing
point.
• You can shift the dividing point up to ±128. This
range (±128) corresponds to approximately ±8
seconds from the original point (Position 0).
When you stop rotating the MULTI JOG dial, the unit
repeats the newly selected dividing point.
• When you find the right position, go to the next step.
Amplifier/tuner
MD recorder
MULTI JOG
Continued
Ex. When you want to divide track 3
ENTER SET CANCEL MD EDIT
MD IN lamp MD Loading slot
0
EN32-52.CA-MD70R[E]/F 98.11.6, 11:56 am 33