JVC CA-MD70R - Manual (Page 7)

– 6 –
English
Getting Started
Unpacking
After unpacking, check to be sure that you have all the
following items.
The number in the parentheses indicates the quantity of the
pieces supplied.
• AM loop antenna (1)
• FM antenna (1)
• Remote control (1)
• Batteries (2)
If any is missing, consult your dealer immediately.
Putting the Batteries into the Remote
Control
Insert the batteries — R6P(SUM-3)/AA(15F) — into the
remote control, by matching the polarity (+ and –) on the
batteries with the + and – markings on the battery
compartment.
When the remote control can no longer operate the unit,
replace both batteries at the same time.
1
3
• DO NOT use an old battery together with a new
one.
• DO NOT use different types of batteries together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery
compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, it will be damaged from battery leakage.
R6P(SUM-3)/AA(15F)
Connecting Antennas
FM antenna
1
Attach the FM antenna to the FM 75
Ω
COAXIAL
terminal.
2
Extend the FM antenna.
3
Fasten it up in the position which gives you the best
reception.
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outside FM
antenna.
To connect an outside FM antenna
Before connecting it, disconnect the supplied FM antenna.
FM antenna (supplied)
FM
75
COAXIAL
AM EXT
AM
LOOP
ANTENNA
GND
Outside FM antenna
(not supplied)
FM
75
COAXIA
L AM EXT
AM
LOO
P
ANTENNA
GND
A 75
Ω
antenna with coaxial
type connector (DIN 45325)
should be used.
Continued
2
EN01-18.CA-MD70R[E] 98.10.18, 2:43 am 6