JVC SR-V10U - Manual (Page 25)

EN
25
VIDEO (MONO)L—AUDIO—R S VIDEO
A.DUB
DIGITAL TBC/NR
FF REW
POWER
SP EP VCR REC PAUSE STOP/EJECT
PLAY
– +
CH– /+ PUSH / TURN
INSERT
24HR QUICK
PROGRAM
REC LINK
Using two sets of SR-V10U, a long recording will be
possible (such as camcorder recording, another VCR
playback or TV broadcast).
Use the buttons and controls on the VCR's front
panel for the Series Recording operations (except
when using Mode Lock).
1 Make connections
Connect two sets of SR-V10U to other
equipment, antenna or cable as shown in the
illustration on page 24.
●The mini-plug cable is a mono 3.5 mm mini-
plug to mono 3.5 mm mini-plug connector.
● When connecting a camcorder or another VCR
with an S-VIDEO output connector as recording
source, it is recommended to use the S-VIDEO
connection to minimize picture degradation.
2 Turn on all components
After completing the connections, turn on all the
components.
● Set the TV to video input mode or A/V input
mode. Refer to the TV instruction manual.
3 Set recording VCR's input mode
Set to “AUX“. Press CH + or – to select the input
mode depending on the connector being used –
“L-1“ for the rear AUDIO/VIDEO IN connector,
or “F-1“ for the front AUDIO/VIDEO input
connector.
4
Prepare for recording
Insert the recording cassette into each SR-V10U,
and prepare the playback source.
NOTE:
If you do not want to display the superimposed
indication on the screen during recording, set “ON
SCREEN (REC)“ to “OFF“ (
੬ pg. 37, 38). If the
playback equipment has a superimpose/OSD disable
feature, set its superimpose or display feature to “OFF“
as well.
5
Start recording
Press REC ( ¶ ) on either of SR-V10U. When the
tape remaining time reaches to 2 minutes while
recording, the other SR-V10U successively starts
to record. Therefore, recording will be continued
onto cassettes loaded on two SR-V10U
alternately.
● The cassette will automatically be rewound
when the recording stops.
● Replace the cassette after rewound if you want
to continue to record onto another cassette.
To stop recording
Press STOP/EJECT ( 7 / 0 ) on the SR-V10U which is
recording.
To prohibit operations during Series Recording (Mode
Lock)
Press and hold OK on the Remote for more than 5
seconds. " " and " " light up on the front display panel
(
੬ pg. 60). The picture will be recorded onto the
cassettes alternately without any interruption.
To resume the other operations, press and hold OK on
the Remote again for more than 5 seconds.
● When OK is pressed to set Mode Lock, the on-screen
display appears and the time counter will be recorded
with your picture. If the time counter is not necessary,
set "ON SCREEN (REC)" to "OFF" (
੬ pg. 37, 39).
NOTES:
● Series Recording is also possible using the front AUDIO/
VIDEO connectors.
● When recording a TV broadcast, tune in the same channel on
both SR-V10U.
● If you do not want to record the operational indications on
the screen during Series Recording, set both “ON SCREEN
(PLAY)” and “ON SCREEN (REC)” to “OFF”. (
੬ ␣ pg.␣ 37, 38)
● If there is a power outage during Series Recording, the
recording will resume automatically when the power is
restored to the VCR. (No setting is required for this function.)
STOP/EJECT
(
7 / 0 )
2
5