JVC SR-V10U - Manual (Page 53)

EN
53
This Remote is capable of transmitting two control
codes; one set to respond to A code control signals and
another set to respond to B code control signals.
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote
to respond to B code control signals.
When using two JVC VCRs, set two VCRs and their
Remotes to different codes, so that you can operate these
VCRs separately.
1
Set remote control code for Remote
1 Press and hold A/B.
2 Press the Number key “2”.
3 Press OK, and release A/B.
● The Remote now can transmit B code control
signals.
2
Check remote control code for VCR
Press and hold PLAY ( 3 ) on the VCR for more
than 5␣ seconds while the VCR is turned off. The
code currently set appears on the display panel.
3 Change code for VCR
Press any key on the Remote.
● The VCR now responds to B code control
signals.
● To set the Remote and the VCR back to A code
control signals, repeat the same procedure as
shown above except pressing the Number key
“1” in step 2 of 1.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote
control code for the Remote between A and B (
੬ step
1), keeping two VCRs to different control codes.
● Press the Number key “1” for A code control signals
and the Number key “2” for B code control signals. (To
change only the remote control code for the Remote,
DO NOT perform steps 2 and 3 .)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
1 2 3
4 5 6
7 8 9
0
2
4
1
3
1
–2
1
–3
1
–1, 3
MBR SET
A/B
2
OK 3
ENTER/O
SD
VIDEO (MONO)L—AUDIO—R S VIDEO
A.DUB
DIGITAL TBC/NR
FF REW
POWER
SP EP VCR REC PAUSE STOP/EJECT
PLAY
– +
CH– /+ PUSH / TURN
INSERT
24HR QUICK PROGRAM
REC LINK
2