When programs overlap each other, Timer recording (cont.), Confirm overlapping programs – JVC SR-V10U User Manual
Page 36: Select program to modify, Cancel or change program setting
36
EN
When programs overlap each
other
If “PROGRAM NOT COMPLETED PROGRAM
OVERLAP” appears, you have another program
overlapping the program you have just made.
The Program Check screen appears and conflicting
programs will start blinking.
EX. Program 1 (you have just made) and Program 4
overlap each other
1
Confirm overlapping programs
Overlapping programs blink on the screen.
2
Select program to modify
Press SHUTTLE PLUS
%fi, then press SHUTTLE
PLUS
#.
• You can only select one of the overlapping
programs.
NOTE:
If you do not mind this overlap, press
PROG.
to finish the
timer program setting. See “ATTENTION” to the right.
Without doing anything for about 1 minute, the VCR will
finish the timer programing.
C
PROGRAM NOT COMPLETED
PROGRAM OVERLAP
PR START
STOP
CH
DATE
1
8:00P
11:00
12 12/24
2
10:00A
10:45
40 12/25
3
11:30P
1:00
125
12/25
4
9:00P
10:00
10 12/24
5
6
7
8
(
5,∞), THEN (
3
) (PROG.) : END
PROGRAM 4
START
STOP
9:00 PM
= 10:00PM
DATE
CH
12/24/00
10 SP
SUN
PRESS (CANCEL) TO CANCEL
PRESS (OK) TO CONFIRM
PRESS (PROG.) TO END
ATTENTION
If there is a conflict in the timer schedule and one program
overlaps with another, only the parts shown below in gray
will be recorded.
Pattern 1:
The program with the lower program
number will be recorded.
Pattern 2:
The program starting earlier will be
recorded.
Pattern 3:
The program starting earlier will be
recorded, followed by the remaining portion
of the other program.
1
2
3
4
5
6
7
8
9
0
2
4
1
3
C
–
3
C
–
3
C
–
3
C
–
2
C
–
2
C
–
3
3
Cancel or change program setting
To cancel a program,
press CANCEL when the
Program screen you do
not want is shown.
“PROGRAM
COMPLETED” appears on
the screen for about
5␣ seconds, then normal
screen appears.
To change a program, press the appropriate button:
START+/–, STOP+/–, DATE+/–, CH+/–, and/or SP/
EP when the Program screen on which you want to
make changes is shown, then press OK.
“PROGRAM COMPLETED” appears on the screen
for about 5 seconds, then normal screen appears.
NOTE:
If the overlap is not yet solved or another overlap occurs
with the timer program setting made last after making
correction on a program, the conflicting programs will be
shown on the Program Check screen again. Repeat the
above steps again until the overlap is solved.
10:00
11:00
12:00
CH10
CH40
Not recorded
Program 1
Program 2
10:00
11:00
12:00
CH10
Program 2
Not recorded
Program 1
CH40
10:00
11:00
12:00
CH10
CH40
Program 1
Program 2
Not recorded
TIMER RECORDING (cont.)