Sterling Trucks Acterra MX - Manual (Page 21)

IMPORTANT: After performing all operations in this
table, perform all daily and weekly maintenance op-
erations listed in the "Pretrip Inspection and Daily
Maintenance" chapter of the vehicle driver’s manual.
Also, perform all M1 Maintenance Interval Operations
at the Initial Maintenance (IM). NOTE: Numbers in this table are maintenance opera-
tion reference numbers matching those in the text of
this manual. The Initial Maintenance consists of all
M1 Operations plus the other operations listed below.
Initial Maintenance (IM) Operations
Maint.
Oper. No.
Initial Maintenance (IM) Operations
00–10 Perform All M1 Operations
25–02 Clutch (Pull-Type) Inspecting and Adjusting
26–02 Eaton Fuller and TTC Transmission Fluid Changing and Magnetic Plug
Cleaning
*
31–01 Frame Fastener Torque Checking
32–03 U-Bolt Torque Checking
33–04 All-Axle Alignment Checking
33–07 Draw Key Nut Inspecting
35–03 Axle Lubricant Changing and Magnetic Plug Cleaning
35–04 Two-Speed-Axle Shift Unit Oil Level Checking
* IM interval does not apply to vehicles with a factory fill of Eaton approved synthetic lubricant.
General Information
00
Initial Maintenance (IM) Operations Table: 00–09
Acterra Maintenance Manual, October 2008 00/14