M3 maintenance interval operations table, General information – Sterling Trucks Acterra MX User Manual
Page 25
IMPORTANT: After performing all operations listed in
this table, perform all daily, weekly, and monthly
maintenance operations listed in the "Pretrip and
Post-Trip Inspections and Maintenance" chapter of
the
Acterra
®
Driver’s Manual. Also, perform all M1
and M2 Maintenance Interval Operations at the M3
Maintenance Interval.
NOTE: Numbers in this table are maintenance opera-
tion reference numbers matching those in the text of
this manual. The M3 Maintenance consists of all M1
and M2 Interval Operations plus the other operations
listed below.
M3 Maintenance Interval Operations
Maint.
Oper. No.
M3 Maintenance Interval Operations
Perform All M1 Operations
Perform All M2 Operations
Engine Drive Belt Inspecting
Air Cleaner Element Inspecting and Replacing
Clutch (Pull-Type) Inspecting and Adjusting
Allison Transmission Fluid and Filter Changing
U-Bolt Torque Checking
All-Wheel-Drive Front Axle Oil Changing
Draw Key Nut Inspecting
Two-Speed-Axle Shift Unit Oil Changing
Wheel Nut Checking
Air Dryer Checking, Bendix AD–9
Fuel Tank Draining and Vent Checking
Electrical System Checking
General Information
00
M3 Maintenance Interval Operations Table: 00–12
Acterra Maintenance Manual, October 2008
00/18