M2 maintenance interval operations table, General information – Sterling Trucks Acterra MX User Manual
Page 24
IMPORTANT: After performing all operations listed in
this table, perform all daily, weekly, and monthly
maintenance operations listed in the "Pretrip and
Post-Trip Inspections and Maintenance" chapter of
the
Acterra
®
Driver’s Manual. Also, perform all M1
Maintenance Interval Operations at the M2 Mainte-
nance Interval.
NOTE: Maintenance operations appearing in italics in
this table are for noise emission control components.
Numbers in this table are maintenance operation ref-
erence numbers matching those in the text of this
manual. The M2 Maintenance consists of all M1 In-
terval Operations plus the other operations listed
below.
M2 Maintenance Interval Operations
Maint.
Oper. No.
M2 Maintenance Interval Operations
Perform All M1 Operations
Lubrication and Fluid Level Check:
•
Two-Speed-Axle Shift Unit Oil Level Checking
•
Camshaft Bracket Bushing Lubricating
•
Air Reservoir Automatic Drain Valve Disassembly, Cleaning, Inspect-
ing, and Lubricating, Bendix DV–2
•
Bosch Rail-Slide Hydraulic Brake Caliper Lubricating
•
Steering Driveline Lubricating
Air Compressor Inspecting, Bendix
Radiator Cap Checking
Fan Clutch Checking
Allison, Eaton/Fuller, and Meritor Transmission Breather Checking
Automatic Slack Adjuster Inspecting, Meritor
Exhaust System Inspecting
HVAC Air Filter Replacing
*
*
Replace the HVAC filter every 6 months regardless of mileage.
General Information
00
M2 Maintenance Interval Operations Table: 00–11
Acterra Maintenance Manual, October 2008
00/17