Sanyo POA-PN03C - Manual (Page 23)


PJ-NET ORGANIZER
OWNER'S MANUAL [XP100 Series]
ENGLISH
How to enter the numbers with the screen 10-key pallet
1
Select a column with a red frame by using the point buttons 7 8 .
2
Press SELECT button. The screen 10-key pallet appears on the screen.
3
By using the point buttons (d e 7 8), select numbers 0 to 9 and press SELECT button.
Repeat the above to enter the complete number on the column.
* To change the number in a column, select “C” and press SELECT button to clear the number in
the column and then enter the number again.
4
After entering the number in the column, select a move key (7 8 e d) located on the lower
part of the pallet by using the point buttons and press SELECT button repeatedly to move
the red frame.
5
Repeat steps 3 to 4 for entering all the network address.
6
After finishing, select "Exit" and press SELECT button. The 10-key pallet disappears on the
screen.
Installation and network configuration
Exit
10-key pallet
How to enter the numbers with the remote control 10-key buttons
During the network address input mode or the network PIN
code input mode, some of the buttons on the remote control
are operate as the 10-key input buttons.
1
Select a column with a red frame by using the point buttons 7
or 8 .
2
Press 0 to 9 key assigned to the buttons to enter the numbers..
* To change the number in a column, enter the number again.
3
After entering the number in the column, press the point but-
tons 7 or 8 to move the red frame.
4
Repeat steps 1 to 3 for entering all the network address.
During the numbers
input mode, these
buttons operate as the
10 key buttons