Sanyo DSR-3709 - Manual (Page 114)

English
113
2
SPECIFICATIONS
Note that product appearance and specifications are subject to change without prior notice.
Specifications
Product name Digital video recorder with multiplexer function
Product number DSR-3716 (16 channel), DSR-3709 (9 channel)
Hard disk capacity Capability for mounting 80, 160, 250, or 300 GB hard disks (sold separately)
Television system NTSC signal standard
Compression Image: M-JPEG, Audio: WAVE
Picture resolution 720 x 240 (fields)
Recording type Field recording
Picture quality 5 levels [Basic, Normal, Enhanced, Fine, Super Fine]
Recording rate 27 levels (60 to 0.033 FPS)
Recording areas Normal recording area, Alarm recording area, Archive area
Magnification x2 digital zoom using the [ZOOM] button
Search modes Time/date search, Alarm search, Alarm thumbnail search, Archive area search, Motion detection search
Date/clock settings Month, Day, Year (last two digits), Hours, Minutes, Seconds
Date and time positions 2 position; upper and lower (display may also be turned off)
Camera title display Each channel; up to 10 alphanumeric characters and symbols (display may also be turned off)
Memory backup Approximately 30 days (for 48 hours of electrification)
Video input terminal VBS/VS 1.0 V (p-p), 75 Ω, BNC (DSR-3716: x16, DSR-3709: x9)
Video output terminal Through output of each video input, BNC (DSR-3716: x16, DSR-3709: x9)
Main monitor output terminal VBS 1.0 V (p-p), 75 Ω, BNC (x1)
Monitor 2 output terminal VBS/VS 1.0 V (p-p), 75 Ω, BNC (x1)
Audio input terminal -8 dBs, 27 k Ω, unbalanced RCA (x1)
Audio output terminal -8 dBs, 600 Ω, unbalanced RCA (x1)
Microphone input terminal -60 dBs, 10 k Ω, unbalanced 3.5 mm monaural pin jack (x1)
Front AV
output Video output terminal 1.0 Vp-p, 75 Ω, unbalanced RCA x 1
Audio output terminal -8 dBs, 600 Ω, unbalanced RCA x 1
CompactFlash card slot CompactFlash Type 2 (front panel) (x1)
Terminals
LAN terminal
10BASE-T/100BASE-TX, RJ-45 (x1)
Compatible protocol: UDP, TCP/IP, HTTP server
RS-485 terminal RJ-11 (x2) (with a termination switch)
USB terminal USB 1.1 series A terminal (x2) (front x1, rear x1)
Alarm input terminals No-volt contacts (with a pulse width of 100 ms or more) (DSR-3716: x16, DSR-3709: x9)
Sensor alarm output terminals Open collector, Low level active (Max. 25 mA) (DSR-3716: x16, DSR-3709: x9)
Remote control input terminal Two-wire voltage control (x2)
Clock adjust input terminal
No-volt contacts (with a pulse width of 100 ms or more) (x1)
Clock adjust output terminal Normal 5 V DC, Low level active (x1)
Alarm output terminal Active Low, Open collector Max. 500 mA (x1)
Alarm reset input terminal No-volt contacts (with a pulse width of 100 ms or more) (x1)
Warning output terminal Normal 5 V DC, Low level active (x1)
Normal recording area disk
full warning output terminal
Normal 5 V DC, Low level active (x1)
Alarm recording area disk full
warning output terminal
Normal 5 V DC, Low level active (x1)
Series connection input Normal 5 V DC, Low level active (x1)
Series connection output Normal 5 V DC, Low level active (x1)
External timer input terminal No-volt contacts (with a pulse width of 1 second or more) (x1)
Non rec output terminal Normal 5 V DC, Low level active (x1)
Power supply voltage 120 to 240 V AC, 50/60 Hz
Current consumption 600 mA
Allowable operating temperature 5 °C to 40 °C
Allowable operating humidity 10 % to 80 %
Dimensions 420 (W) x 86 (H) x 365 (D) mm (Not including protruding areas or rubber pads)
Weight 6.3 kg with a HDD, 6.9 kg with 2 HDDs
Accessory Power cord (x1), Core clamp (x2), Power cord tie (x1)
e00_l8hbg_us_7.book Page 113 Thursday, November 25, 2004 1:44 PM