Sanyo DSR-3709 - Manual (Page 82)

RECORD SET 3
English
81
Use this setting to indicate how alarms are to be detected.
1
Turn the jog dial to select “ALARM
TRIGGER”, and then turn the shuttle
dial clockwise.
“ALARM” flashes in the “ALARM TRIGGER” field.
2
Turn the jog dial to select an alarm
detection method, and then turn the
shuttle dial clockwise.
[Settings] (‹ indicates default setting)
[Setting conditions]
z
When sensor selection has been made (i.e.,
“SENSOR”, “ALARM AND SENSOR”, or “ALARM OR
SENSOR”) it will be necessary to set the motion
sensors.
z The digital video recorder supports the coaxial alarm
signal from coaxial superimposition cameras. When a
coaxial alarm is input, it is treated as an external alarm.
Use the following procedure to set motion sensor on video
from each camera so that alarms can be detected.
(1) Motion sensor setting
Displays changes in response to the sensor condition,
and settings are made turning the jog dial.
-: Sensor off
A or B: Sensor on
(2) Camera number display
Changes when a [CAMERA SELECT] button is
pressed. Use this item to select the camera for which
motion sensors are to be setup.
(3) Time period
Select an interval as set using “TIME PERIOD” on
P.57.
(4) LEVEL
Sets the sensitivity level of the motion sensors.
OFF: No motion sensor has been set.
1 to 10: A motion sensor is set. Lower values
correspond to higher sensitivity levels and vice versa.
(5) MODE
Sets the detection method for the motion sensors.
(JP.83)
z Refer to “NAMES AND FUNCTIONS OF PARTS” for
more details regarding operation of the jog dial and
shuttle dial. (JP.9)
Setting the alarm trigger
Setting Description
‹ ALARM
Alarm recording is performed when an
external alarm is generated (i.e.,
when a switch is attached to the alarm
input terminal on the rear panel, and
the switch is activated).
SENSOR
Alarm recording is performed when a
motion sensor detects movement.
See the section on setting motion
sensors for more details.
ALARM AND
SENSOR
Alarm recording is performed when
both the external alarm and a motion
sensor are activated simultaneously.
ALARM OR SENSOR
Alarm recording is performed when
either the external alarm or a motion
sensor is activated.
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : ON
ALARM INTERLEAVE : ONLY
REC RATE: A 15FPS, DURATION: 20SEC
PRE-ALARM RECORDING : ON
REC RATE: A 30FPS, DURATION: 1MIN
=> (00229 ALARMS CAN BE RECORDED)
ALARM TRIGGER : ALARM
MOTION SENSOR ->
Setting the motion sensors
CH01 T-1 LEVEL : OFF MODE : A
(1)
(2)
(3) (4) (5)
e00_l8hbg_us_7.book Page 81 Thursday, November 25, 2004 1:44 PM