Sanyo DSR-3709 User Manual
Page 88
GENERAL SET
4
English
87
2
Turn the jog dial to select “1. DISPLAY
SET”, and then turn the shuttle dial
clockwise.
The <DISPLAY SET> screen is displayed.
3
Turn the shuttle dial clockwise.
“ON” for the (1) “DATE” flashes. This can be set to “OFF”
turning the jog dial to remove the date from the operation
display area.
4
Turn the shuttle dial clockwise.
The cursor moves to the time entry.
The following settings are carried out with the shuttle
dial and jog dial.
z
Vertical cursor movement: Turn the jog dial.
z
Cursor movement to the right: Turn the shuttle dial
clockwise.
z
Modification of values: Turn the shuttle dial clockwise,
and then with the setting value flashing, turn the jog
dial.
z
Confirmation of values: Turn the shuttle dial clockwise.
5
Perform the following if so required.
z
TIME (OFF):
Time is not displayed during recording or playback.
z
QUALITY (OFF):
Picture quality mode is not displayed during recording
or playback.
z
AUDIO (OFF):
Audio recording settings are not displayed during
recording or playback.
z
ALARM COUNT (OFF):
The current number of alarms is not displayed.
z
ALARM TYPE (OFF):
The type of alarm recording is not displayed.
z
TITLE (OFF):
Camera titles are not displayed.
The content of the operation display area
changes when the setting for “ALARM
RECORDING” (JP.77) from <ALARM REC
MODE SET> is switched.
When turned “OFF”:
The alarm count and type are not displayed.
When turned “ENABLED”:
The operation display area changes as follows.
z
“ALARM” is displayed when alarm video is recorded or
played back.
z
“PRE” is displayed when pre-alarm video is recorded or
played back.
z
“ARCHIV” is displayed for playback from the archive area.
6
Press the [EXIT/OSD] button.
The setting procedure is ended and the display returns to
the normal screen.
z
A maximum of 9,999 alarms can be displayed in the
operation display area. When this number is exceeded,
the count returns to 0000.
\
Use the following procedure to display “VIDEO LOSS!”
when the camera video is interrupted.
1
Turn the jog dial to select “VIDEO
LOSS”, and then turn the shuttle dial
clockwise.
2
Turn the jog dial to display “ON”, and
then turn the shuttle dial clockwise.
3
Press the [EXIT/OSD] button.
The setting procedure is ended and the display returns to
the normal screen.
<DISPLAY SET>
DATE : ON
TIME : ON
QUALITY : ON
AUDIO : ON
ALARM COUNT : ON
ALARM TYPE : ON
TITLE : ON
VIDEO LOSS : ON
01-01-04 00:00:00 REC 1% EN A ALARM 0000
02
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(1)
(2)
(6)
(3)(4)
(5)
(7)
Setting display for video loss
EXIT/OSD
<DISPLAY SET>
DATE : ON
TIME : ON
QUALITY : ON
AUDIO : ON
ALARM COUNT : ON
ALARM TYPE : ON
TITLE : ON
VIDEO LOSS : ON
EXIT/OSD
e00_l8hbg_us_7.book Page 87 Thursday, November 25, 2004 1:44 PM