Samsung SPR-7416 - Manual (Page 32)

3-3
Input Sensor No.
: Select whether to use the sensor inerworking the camera.
: The sensor interworks with the corresponding camera.
: The sensor does not interwork with the corresponding camera.
If a signal is generated is inputted in the sensor interworking with the camera, camera
images will be recorded according to the frame rates setting.
Input Motion No.
: Select whether to use the motion inerworking the camera.
: The motion interworks with the corresponding camera.
: The motion does not interwork with the corresponding camera.
Select time(S)
: Set the Time to record camera images when signals are inputted in the sensor or motion
Interworking with each camera during an emergency. (The conversion time is from 3
seconds to 3 minutes.) Description
Video loss Alarm
: Alarm and beep are generated through he control number that is inerlocked when Video
Video Loss is generated.
1) Alarm
When Alarm button is pressed : Alarm is activated.
When Alarm button is released : Alarm is not activated.
2) Beep
When Beep button is pressed : Beep is activated.
When Beep button is released : Beep is not activated.
3) Alarm Duration
You can set he duration when alarm and beep tone are generated by this function.
You can select a control number that is interlocked by Control Interlocking when Video
Loss is generated.
Duration can be set by hour , minute or seconds.
Recording/Display [Display]
3-3
Environment Setup