Samsung SPR-7416 - Manual (Page 64)

5-9
Appendix
5-9
9
SSC-2000 system keyboard
Description
LCD Display
: This displays the active status of system keyboard.
Camera action related keys
- PRESET - PATTERN
- SCAN - AUTO PAN
Alarm release key
: This function is to force to stop the alarm output when an alarm sounds in DVR.
Joystick Controller (UP/DOWN/LEFT/RIGHT/AF)
: This function is used to move the action of Pan/Tilt connected to SAMSUNG Dome
Camera or Receiver unit up/down/left/right and control the action of Auto Focus. In
addition, this is used to control the action of Zoom by turning it clockwise or
counterclockwise.
(When controlling the DVR, this can be used as a mouse to select the menu displayed on
the screen.)
Camera lens related keys
- IRIS control (IRIS CLOSE / OPEN)
- FOCUS control (FOCUS NEAR / FAR)
- ZOOM control (ZOOM TELE / WIDE)
MENU KEY
: This is used to return to Menu mode in order to set each device.
Control Device selection keys (MON/CAM/MUX/DVR)
: This is used to designate Camera, Monitor, DVR, MUX Number etc.
Numeric key (0~9), ENTER key, CLEAR key
: This is used to designate Camera, monitor, DVR, MUX Number, Preset, Pattern Number etc.
DVR Control keys (SEQUENCE, MODE)
- SEQUENCE : If you select SEQUENCE button after changing over by 4 and 9 division
mode from the monitoring screen, the division screen shall be changed over
in sequence.
JOG/SHUTTLE
: When controlling the DVR, this enables to search the recorded picture of the desired time
zone by moving the search bar left/right from the DVR search screen.
DVR Reproduction related keys
: When searching the recorded picture from DVR search screen, this is used to move the
picture to the very first line or last line, or reproduce it in clockwise direction or stop it.
[Notice]
-. Connect SCC-200 through the terminal of RS-485 or RS-422 in the rear of DVR.
-. Connect the signal(+) of the terminal of DVR RS-485 or RS-422 to Tx(+) of SSC-2000.
-. Connect the signal(-) of the terminal of DVR RS-485 or RS-422 to Tx(-) of SSC-2000.
-. For further information of SSC-2000, please refer to User s Manual of SSC-2000.
move to the first data of the selected date
stop
reproduction in clockwise direction/pause
move to the last data of the selected date
SSC-2000 System Keyboard is the controller to control the DVR by using a RS-485.
The user can operate a DVR conveniently as the user friendly on screen display, touch screen and
joy stick are applied to the system. (SSC-2000 available Rev. NO : Ver 1.5 or Higher)