Sony STR-DA7100ES - Manual (Page 105)

105 GB
Ad
v
a
nce
d
Spe
ake
rs
Se
t Up
x CENTER BASS xxx dB (Center
speaker bass level)
Initial setting: 0 dB
You can adjust the level from –10 dB to +10
dB in 1 dB steps.
x CENTER MID xxx dB (Center
speaker midrange level)
Initial setting: 0 dB
You can adjust the level from –10 dB to +10
dB in 1 dB steps.
x CENTER MID xxx Hz (Center
speaker midrange frequency)
Initial setting: 1 kHz
You can adjust the frequency from 100 Hz to
10 kHz in 5 steps.
x CENTER TREBLE xxx dB
(Center speaker treble level)
Initial setting: 0 dB
You can adjust the level from –10 dB to +10
dB in 1 dB steps.
x SURR/SB BASS xxx dB
(Surround/surround back
speaker bass level)
Initial setting: 0 dB
You can adjust the level from –10 dB to +10
dB in 1 dB steps.
x SURR/SB TRE. xxx dB
(Surround/surround back
speaker treble level)
Initial setting: 0 dB
You can adjust the level from –10 dB to +10
dB in 1 dB steps.
x PRESET x CLEAR (Equalizer
bank clear)
You can reset the adjusted equalizer settings to
the initial setting. For details, see “Clearing
stored equalizer settings.”
Tip
You can adjust the front speaker bass and treble level
with BASS control and TREBLE control on the
receiver.
To apply the stored equalizer
1
Perform step1 to 3 in “Adjusting the
equalizer” on page 104.
2 Move the control key B/b to select (EQ
PRESET [1]-[5]).
You can also use +/– on the receiver.
To turn off the equalizer
Select “EQ BANK [OFF]” in step 4 in
“Adjusting the equalizer” on page 104.
Clearing stored equalizer
settings
1
Perform step1 to 3 in “Adjusting the
equalizer” on page 104.
2 Move the control key B/b to select the
equalizer (EQ PRESET [1]-[5]) you
want to clear.
You can also use +/– on the receiver.
3 Move the control key V/v to select
“PRESET x CLEAR.”
You can also use MENU on the receiver.
“x” is the number of the selected equalizer
bank.
4
Move the control key B/b to select
“YES,” then press the key.
You can also use +/– and MEMORY/
ENTER on the receiver.
“Are you sure?” appears on the display.
5 Move the control key B/b to select
“YES,” then press the key.
You can also use +/– and MEMORY/
ENTER on the receiver.
“PRESET x CLEARED!” appears on the
display and the adjusted contents of the
selected equalizer bank are cleared.