Sony STR-DA7100ES - Manual (Page 116)

116 GB
To erase a programmed IR code
1
In step 5, move the easy scroll key to
select “Common,” then press the key to
enter the selection.
2 Move the easy scroll key to select “NO
SET,” then press the key to enter the
selection.
To delay the output of an IR
code
1 In step 5, move the easy scroll key to
select “Common,” then press the key to
enter the selection.
2 Move the easy scroll key to select
“WAIT TIME,” then press the key to
enter the selection.
3 Move the easy scroll key to select the
time to delay the output of an IR code,
then press the key to enter the
selection. You can specify a delay of
from 1 to 10 seconds (in 1 second
increments).
Notes
• Pressing any of the following buttons during a
macro play operation will cancel the macro play
sequence before it is complete.
– AV ?/1
– ?/1
– SYSTEM STANDBY
– SOUND FIELD
– INPUT SELECTOR
– RM SET UP
• When the Macro Play function does not work
properly, set “WAIT TIME” between each
operation.
Setting remote control
codes that are not stored
in the commander
When a remote control code is not one of the
presets stored in the commander, it is possible
for the commander to learn the code using the
Learning function.
1
Press RM SET UP.
The set up list appears.
2
Move the easy scroll key to
select “LEARNING,” then press
the key to enter the selection.
The input list appears.
3
Move the easy scroll key to
select the function for which
you want to use the Learning
input, then press the key to
enter the selection.
The button list appears.
4
Move the easy scroll key to
select the button you want to
use for the Learning function,
then press the key to enter the
selection.
The display for the learning function
appears.
1
2,3,
4,6