SIGMA SQC-122c - Manual (Page 37)

Chapter 3 Menus
3-4
3.2 Next Menu Screens
The Next Menu SoftKey provides access to two sub-menus of the Main Menu that
control display and operating mode preferences.
Next Menu Screens
Zero Zeros the thickness reading. Useful for resetting or extending
the current deposition layer.
Auto /
Manual Toggles between Auto and Manual power control. When
Auto/Manual is shown, output power is set by the SQC-122c to
achieve the programmed deposition rate. When Manual/Auto
is shown, the control knob sets the output power.
Next
Graph Cycles through options for the main display. Choose between
Rate, Rate Deviation, and Power graphs.
Switch
Displays Toggles between data display options at the bottom of the
SQC-122c screen. Note the differences between the screens
above, and the Main Menu screen in the previous section.
Sensor Info Replaces the graph with the sensor information screen:
THICKNESS(kA)
0.000
RATE(A/s)
0.0
POWER(%)
0.0
PHASE: Stopped
100.0
50.0
0.0
0.0 25.0 50.0
Power ( % vs. Time)
Next
Menu
Next
Graph
Switch
Displays
Start
12.5 37.5
Sensor
Info
Run #: 1
5-16-00
8:22:39
Source: 1
Max Pow:: 100.00 %
Slew: 100.00 %
THICKNESS(kA)
0.000
RATE(A/s)
0.0
POWER(%)
0.0
PHASE: Stopped
100.0
50.0
0.0
0.0 25.0 50.0
Power (% vs. Time)
Next
Menu
Zero
Auto /
Manual
Start
12.5 37.5
Run #: 1
5-16-00
8:22:39
Source: 1
Max Pow:: 100.00 %
Slew: 100.00 %
THICKNESS(kA)
0.000
RATE(A/s)
0.0
POWER( %)
0.0
Next
Menu
Sensor # Enable Frequency Life
1
2
ON
ON
5.543210 MHz
5.654321 MHz
54.32 %
65.43 %