Sun Microsystems 2000E - Manual (Page 16)

1-4 SPARCserver 2000E Power Supply Installation Manual—April 1995
1
Warning – This equipment contains lethal voltages. Accidental contact can
result in serious injury or death.
Caution – Improper handling by unqualified personnel can cause serious
damage to this equipment. Unqualified personnel who tamper with this
equipment may be held liable for any resulting damage to the equipment.
Persons who remove any of the outer panels to access this equipment must
observe all safety precautions and ensure compliance with skill level
requirements, certification, and all applicable local and national laws.
All procedures contained in this document must be performed by qualified
service-trained maintenance providers.
Caution – Before you begin, carefully read each of the procedures in this
manual. If you have not performed similar operations on comparable
equipment, do not attempt to perform these procedures.
1.3 Tools Required
The following list represents the minimum of tools and test equipment
required to service the system cabinet:
•
Screwdriver, slotted, 3/16 inch
•
Screwdriver, Phillips #2
• Screwdriver, Phillips #1
•
Hex driver, M-4
•
Hex driver, 3/16 inch
• Hex driver, 9 mm
•
Wrench, 13 mm
•
DIP/IC extraction tool
• ESD mat, Sun P/N 250-1088, or equivalent
•
Grounding wrist strap
•
Needlenose pliers
!
!