Sun Microsystems 2000E - Manual (Page 34)

2-18 SPARCserver 2000E Power Supply Installation Manual—April 1995
2
2.5.2.6 Power Supply Sense Cable
1. Remove the jumper-connector from the power supply adapter board.
You will find this device plugged into the connector nearest the outside
edge of the cabinet. Remove it. See Figure 2-18.
2. Plug the sense cable for the bottom power supply into the power supply
adapter board.
Plug it into the near-most connector — from which the jumper-connector
was removed in Step 2.
3. Plug the other end of the sense cable into the sense connector on the
bottom power supply.
Plug it into J1 near the top of the supply.
Figure 2-18 Removing the Jumper-Connector and Installing the Sense Cable
Power supply
adapter board
Jumper connector: Remove to allow the
lower power supply cable sense cable to be
plugged into this connector.
Power supply sense cable
for bottom power supply