Sun Microsystems 2000E - Manual (Page 48)

A-6 SPARCserver 2000E Power Supply Installation Manual—April 1995
A
2. Tilt the panel top out and lift it free of the chassis. Set the panel aside.
There is a flange on the bottom of the rear screen.
Figure 1-5 Rear Screen Panel Removal
A.2 Closing the System
A.2.1 EMI Panel
1. Hold the panel by the handle at the top. Position the panel in the opening
so the bottom flange fits over the lip at the bottom of the opening.
2. Tilt the panel flush against the chassis. Install and tighten all screws.
A.2.2 Rear Screen Panel
1. Insert the panel so the bottom flange engages behind the top of the kick
panel.
2. Tilt the panel flush against the frame and secure using two screws.
Rear screen panel
Kick panel
#10 Phillips screws