Sun Microsystems 2000E - Manual (Page 29)

Power Supply Installation 2-13
2
Figure 2-12 Installing the Main Bus Bar
2.5.2.4 Power Harness Installation
Install the power harness, Part No. 530-2164-xx (comprised of four bus wires)
to connect the two power supplies.
1. Orient the power harness as shown in Figure 2-13.
2. Connect the power harness to the top power supply.
Push four spade connectors onto the spade lugs. See Figure 2-13.
3. Connect the power harness to the bottom power supply.
Push four spade connectors onto the spade lugs.
4. Secure the power harness to the cover panels.
Clip the power harness into nylon retainers in the top and bottom power
supply cover panels. See Figure 2-14.
Nuts backed by lock and flat
washers (16 places)
Screws, M6 (4 places)
Tabs (8 each)
Main bus bar,
Part No. 340-3136-xx