Remove the breaker box, Remove the power breaker box. see figure27, D. remove the box and set aside – Sun Microsystems 2000E User Manual
Page 24: Figure27 removing the power breaker box, Figure 2-7, Removing the power breaker box
2-8
SPARCserver 2000E Power Supply Installation Manual—April 1995
2
Note – J3 is located on the top of the AC distribution unit, J2 is on the backside.
2. Remove the three Phillips screws and two #6-32 Phillips screws.
3. Carefully remove the power distribution unit from the system chassis.
Remove the Breaker Box
1. Remove the power breaker box. See Figure 2-7.
a. Unplug the power cord from the breaker box going to the top power
supply.
b. Remove two screws from holes in the bottom lip of the breaker box
which secure it to the bottom power supply. Set the screws aside.
c. Unscrew two captive screws at the top of the breaker box securing it to
the top power supply.
d. Remove the box and set aside.
Figure 2-7
Removing the Power Breaker Box
Captive screws (2 places)
Screws (2 places, hidden)