Sony XDCAM PDW-1500 - Manual (Page 108)

C
h
a
p
te
r 8
M
e
nu
s
108
8-3 Extended Menu
a) This is supported from firmware version 1.4.
726 H BLANKING WIDTH Select the horizontal blanking width of the output analog video signal.
narow (narrow): Digital blanking (narrow)
wide: Analog blanking (wide)
When “wide” is selected, the horizontal blanking width complies with
RS170A, and normally the blanking is widened and the image becomes
narrower. It is recommended to select “narow” at the editing stage, then
later, for broadcast transmission to select “wide,” to output a signal
conforming to the standard. Note, however, that “narow” has to be always
selected for SDI signals.
728 OUTPUT SCH PHASE Set the subcarrier H phase.
–512 (–512 (DEC))... 0 (0 (DEC))... 511 (511 (DEC))
731
WIDE MODE a) Specify whether to record and play back with the addition of wide picture
information.
Sub-item
1 INPUT Specify whether to save wide picture information on a disc during
recording.
auto: Automatically record wide picture information when it is detected in
the selected input video signal.
on: Always record wide picture information.
off: Do not record wide picture information.
2 OUTPUT Specify whether to add wide picture information to the output signal
during MPEG IMX playback.
thru (through): Output the video signals of the disc being played back
without adding wide picture information.
auto: When wide picture information is detected on the disc being played
back, add wide picture information to the output video signals.
Notes
• To add wide picture information to the output signal, it is necessary, in
addition to setting this item to “thru,” to operate extended menu item
703 to set line 20 (in 525 line mode) to “thru” or set line 23 (in 625 line
mode) to “thru.”
• In 525 line mode, wide picture information may not be output if VITC
signal insertion position is set to line 20 in extended menu item 601 or
602.
Menu items in the 700s, relating to video control
Item number Item name Settings
Menu items in the 800s, relating to audio control
Item number Item name Settings
802 DIGITAL AUDIO MUTING IN
SHUTTLE MODE Set the audio muting conditions during shuttle playback.
off: Not muted.
on: Muted.
807 AUDIO OUTPUT PHASE Set the output timing of digital audio playback signals (SDI, AES/EBU
only), with 80H as a reference position. Output timing is earlier for values
smaller than 80H and later for values greater than 80H. (80H, 128
samples = approx. 2.7 ms, 80H, 1 sample = approx. 20
μs)
0 (0 (HEX))... 80 (80 (HEX))... FF (FF (HEX)): Values can be set in this
range.
808 INTERNAL AUDIO SIGNAL
GENERATOR Select the operation of the internal audio test signal generator.
silnc (silence): Silent signal.
1kHz (1kHz sine): 1 kHz, –20 dB FS sine wave signal.
When you select SG as the audio input in the input selection section of
the control panel, the audio test signal generated by the internal audio
test signal generator is input.
815 AUDIO SAMPLING RATE
CONVERTER Select the mode of operation of the sampling rate converter for AES/
EBU input to channels 1 to 4.
off: Do not operate.
on: Operate.