Sony XDCAM PDW-1500 - Manual (Page 58)

Cha
p
te
r 5
Sc
en
e Sele
c
tion
58
5-1 Overview
Clips
Material recorded on a disc with this unit is managed in
units called “clips.” A clip contains the material between a
recording start point (In point) and a recording end point
(Out point).
Clips have names beginning with “C,” for example
“C0001.”
Clip lists
Data called a “clip list” is created when you use the scene
selection function to select desired clips from the clips
stored on a disc.
Clip lists have names beginning with “E,” for example
“E0001.” You can save up to 99 clip lists on a disc.
Sub clips (clips in clip lists)
The specified clips (or parts of clips) in a clip list are called
“sub clips.” Sub clips are virtual data specifying ranges in
the original clips. Clip data in the original clips is not
overwritten.
Clip list editing (current clip list)
Clip lists cannot be edited on disc. To edit clip lists, you
need to load them, one at a time, into the unit memory.
The clip list which is currently loaded into the unit memory
is called the “current clip list.”
The current clip list is always the target of sub clip creation
and editing. Clip list playback also uses the current clip
list.
After creating and editing a clip list, you need to save it to
disc.
Clip 1
(C0001)
Clip 2
(C0002)
Clip 3
(C0003)
Clip 4
(C0004)
In point
r
Out point
In point
r
Out point
In point
r
Out point
In point
r
Out
point
r
Clip name
Clip list name
Thumbnails of selected clips
Clip 1
(C0001)
Clip 2
(C0002)
Clip 3
(C0003)
Clip 4
(C0004)
Sub clip 1 Sub clip 2 Sub clip 3
Example: Clip list (E0001)