Siemens MCC-3298 - Manual (Page 40)

38
3 Operating the SAMMS-LV Device
F27 - Address
1. Press the LIST key to view the active setting. Allowable
addresses are 1-224. The factory default is 200.
2. To change the setting, you must be in program mode.
3. Press the UP or DOWN key to scroll through the range of
settings, until the selected setting appears on the display.
4. Press the ENTER key to change the active setting to the
selected setting. The display becomes blank while you hold
down the ENTER key and the SAMMS-LV device stores the
new setting.
5. To exit the program mode, press and hold the (F)unction key
for several seconds. The display will show “Prog.” Press the
UP or DOWN key to change to the display mode.
6. Press the (F)unction key to step through to another function.