Sharp MX-3100N - Manual (Page 678)

7-32
SYSTEM SETTINGS
Contents
Device Control
*1 When a saddle stitch finisher is installed.
*2 When a large capacity tray is installed.
*3 When a stand/1 x 500 sheet paper drawer / stand/2 x 500 sheet paper drawer is installed.
*4 When a saddle stitch finisher or finisher is installed.
*5 When a punch module is installed.
*6 When a color-related problem has occurred.
Item Factory default setting Page
■ Device Control
7-61
●
Other Settings 7-61
X Original Feeding Mode All Disabled 7-61
X Saddle Stitch Position Adjust * 1 0.0 mm 7-61
X Auto Paper Selection Setting Plain Paper 7-61
X Tandem Connection Setting
7-61
‹ IP Address of Slave Machine 0.0.0.0
‹ Port Number 50001
‹ Disabling of Master Machine Mode Disabled
‹ Disabling of Slave Machine Mode Disabled
X Detect Standard in Auto Color Mode 3 7-61
X Registration Adjustment 7-61
X Optimization of a Hard Disk – 7-62
X Clear All Job Log Data – 7-62
● Original Size Detector Setting
7-63 X Original Detection Size Combination Inch-1
X Cancel Detection at Document Glass Disabled
● Disabling of Devices 7-64
X Disabling of Document Feeder Disabled 7-64
X Disabling of Duplex Disabled 7-64
X Disabling of Large Capacity Cassette * 2 Disabled 7-64
X Disabling of Optional Paper Drawer * 3 Disabled 7-64
X Disabling of Tray Settings Disabled 7-64
X Disabling of Finisher * 4 Disabled 7-64
X Disabling of Offset Disabled 7-64
X Disabling of Stapler * 4 Disabled 7-64
X Disabling of Punch * 5 Disabled 7-64
X Disabling of Color Mode * 6 Disabled 7-64
● Fusing Control Settings 16 - 24 lbs. (60 - 90g/m 2 ) 7-64