Sun Microsystems SUN FIRE X2100 - Manual (Page 16)

1-6 Sun Fire X2100 Server Getting Started Guide • April 2006
1.4.2 Installing the Mounting Brackets Onto the Server
Use this procedure to install the mounting brackets onto the sides of the server.
1. Position a mounting bracket against the chassis so that the slide-rail lock is at the
server front, and the three keyed openings on the mounting bracket are aligned with
the three locating pins on the side of the chassis.
FIGURE 1-3 Aligning the Mounting Bracket With the Server Chassis
2. With the heads of the three chassis locating pins protruding though the three
keyed openings in the mounting bracket, pull the mounting bracket toward the
front of the chassis until the mounting-bracket clip locks into place with an
audible click. (See
FIGURE 1-3 .)
3. Verify that the rear locating pin has engaged the mounting-bracket clip. (See
FIGURE 1-3 .)
4. Repeat to install the remaining mounting bracket on the other side of the server.
Chassis front
Slide-rail lock
Mounting-bracket
Mounting bracket
clip